Hi everyone. I built this thing on my own so I left the panels outside for a bit longer than I would have liked and I’m guessing water got in them but now it has condensed and it looks a bit bad. Not the end of the world but any way to get rid of it? You can see it in the front windows on this pic. I just finished it a week ago and was hoping it would be gone by now. Took me 4 full days to finish.
by Complete-glowup
3 Comments
Do your panels have vent tape on them? Either way they should clear up once it gets hot enough.
Wait til it clears up/evaporates, then take out your panels and seal the edges (using duct tape or silicon caulk) to prevent water from getting inside the twin walls.
I used an air compressor and blew the moisture down and out.