Here’s how it works… Clip together multiple hexagons to make the support shapes you need.
This design features a double-hexagon, and has a set of lateral holes to make it easy to tie plants in to. Start with the base, which has legs, and then print as many extra hexagons as you need to assemble your plant support.
This prints well in PLA or PETG. No need for supports.
* The parts clip together using alternating dovetails – no need for any non-printed parts.
* If your printer is dialled in nicely these should fit together nicely and firmly, but you can always dab a little glue on the joints if you need (I’ve not found the need to do this myself)
* When you have two modules already connected, and are joining the third, place the new on in position at an angle with the corner touching the existing ones, and gently twist to align both sides at once.
* If you are adding one where three edges need to be connected at the same time it takes a little more fiddling, but it possible and relies on the plastic being a little flexible.
4 Comments
Here’s how it works… Clip together multiple hexagons to make the support shapes you need.
This design features a double-hexagon, and has a set of lateral holes to make it easy to tie plants in to. Start with the base, which has legs, and then print as many extra hexagons as you need to assemble your plant support.
This prints well in PLA or PETG. No need for supports.
* The parts clip together using alternating dovetails – no need for any non-printed parts.
* If your printer is dialled in nicely these should fit together nicely and firmly, but you can always dab a little glue on the joints if you need (I’ve not found the need to do this myself)
* When you have two modules already connected, and are joining the third, place the new on in position at an angle with the corner touching the existing ones, and gently twist to align both sides at once.
* If you are adding one where three edges need to be connected at the same time it takes a little more fiddling, but it possible and relies on the plastic being a little flexible.
[https://makerworld.com/en/models/1127261](https://makerworld.com/en/models/1127261)
These are lowkey sick
amazing! iv been searching for something to use in my gecko tank! these will be perfect for suppporting the living ivy!
Cool 😎 I love it!!