3D printed hydroponic tower. This is after a month of fiddling with the system. Super happy with the result. The bak choy is easily outgrowing the lettuce. by classictd hydroponics 1 Comment lukeiam0 2 years ago Awesome! If you experience a lot of bleed through, in cura increase the default wall overlap from 10 to 20, even 30%. Use petg. Print solid so no bacteria grows inside the infill. Use h2o2 to get rid of the algae. Write A CommentYou must be logged in to post a comment.
lukeiam0 2 years ago Awesome! If you experience a lot of bleed through, in cura increase the default wall overlap from 10 to 20, even 30%. Use petg. Print solid so no bacteria grows inside the infill. Use h2o2 to get rid of the algae.
1 Comment
Awesome! If you experience a lot of bleed through, in cura increase the default wall overlap from 10 to 20, even 30%.
Use petg. Print solid so no bacteria grows inside the infill. Use h2o2 to get rid of the algae.