First viv I was following the SerpaDesigns tutorial but this won’t cure… or maybe it is cured? Idk I can’t tell ‘cause I can’t get to it.
Do I need to carve down to it? Can I just leave it? Help 🥺
You could maybe try running a really thin metal wire or something to poke a hole and let out any pressure. Though it looks liquid so maybe that’s a good sign! I’ve sometimes had uncured foam under cured foam, and it built up so much pressure that my tank exploded (not meant to make you scared), but if you look at it and it starts to change, maybe even turn to foam or god forbid expand, I’d grab anything stiff and poke into it just so you don’t end up with an explosion.
HesFast
I’d just leave it for a week and then sculpt it however you wish. If you run into an un-cured pocket just let that part be until it cures some more
3 Comments
I had a spot like that too and I just left it…
You could maybe try running a really thin metal wire or something to poke a hole and let out any pressure. Though it looks liquid so maybe that’s a good sign! I’ve sometimes had uncured foam under cured foam, and it built up so much pressure that my tank exploded (not meant to make you scared), but if you look at it and it starts to change, maybe even turn to foam or god forbid expand, I’d grab anything stiff and poke into it just so you don’t end up with an explosion.
I’d just leave it for a week and then sculpt it however you wish. If you run into an un-cured pocket just let that part be until it cures some more