So you’re looking to put power in your garden then look no further in this video we show you how to get power in your garden, the easy way. We are going to be installing a weatherproof socket to the back of this house so we can have easy garden power for the customer to mow his lawn. In this video. We show you the complete installation of this weatherproof socket where we get the power from how we do the electrical testing, including some hints and tips on easily installing garden power
00:00 Introduction
01:05 Drilling through the wall
01:52 parts you need to fit a outside socket
03:23 how to install conduit
04:26 how to bend conduit
07:43 how to install a outside socket
09:01 best cable on the market
12:08 taking a spur off a socket
Click here to visit our Website 👉 https://www.greenhawkconstruction.co.uk/
CLICK ON THE LINK FOR YOUR FREE 14 DAY TRADIFY TRIAL USE PROMO CODE GHAWK30 FOR 30% OFF FOR THE FIRST 3 MONTHS LINK👉 https://bit.ly/3bDRfdk
Click here to follow us on Instagram
👉 https://www.instagram.com/greenhawkconstruction/https://bit.ly/3Nmql8u
14 Comments
Tidy work. Does the conduit need to be glued/cemented or not?
Do you ever come out the back of a switched fuse spur next to the indoor socket so you can isolate the garden incase of nuisance tripping with the wet environment or is that just extra work and not really necessary?
Hi! Mate that is very interesting out door socket nearly done but does it better to use spurs instead connect in ring thanks
I think I would be tempted to use an inspection elbow if it was more visible as you can get tighter into the corner still a good job though.
Great video mate, keep up the great work 👍🏻
Neat install, just a small nit pick about no grommet used in that backbox.
Bob’s too heavy for Jack to carry tell him to walk.
I've done this at two locations and put in an isolator switch at both for safety. Why didn't you do it.
He says he's soaking twice and needs to get on with the job…..continues to yap!!!
Great vid! Me from another country with also lots of rain. Why not mount outlet of endboxes down do ground level so no water can come in to the connexions?
I would never double wires with a snips
why just silicon on the inside, and not with rubber grommit around the breakout
Really good vid👍
Always over bend your right angle slightly and when it springs back it's correct.