I want to put my automatic misting control up, and due to the short wire from the control valve thing, I have to attach it to a glass panel.
I can run wood across and just screw it into the wood, but I feel like perhaps there is some sort of suction cup that exists that could work? Or worst case, maybe alien tape?
I would like it to look nice.
Any ideas?
by _rockalita_
4 Comments
You can extend the wire with a bit of wire and some soldering or crimp terminals and some heat shrink tubing to make the junction look nice. I’d rather do that than block the glass/risk it falling from a suction cup failing.
Use a long screw to attach it to the wooden post that the conduit is attached to. A 4” screw should allow you the depth to mount it over the conduit and keep it level and flat.
You could also use allthread and hang it down from the ceiling pretty easily.
Screw a piece of 3/4 inch board to the window frame that is a little bigger than the control board.